low gear
英 [ləʊ ɡɪə(r)]
美 [loʊ ɡɪr]
低速齿轮；低（速）档
英英释义
noun
- the lowest forward gear ratio in the gear box of a motor vehicle
双语例句
- With the development to high-speed 、 over loading 、 precision 、 high potency and low noise in gear drive, the department of manufacturing and processing demands a higher technological content from the design and strength of gear.
随着齿轮传动向着高速、重载、精密、高效、低噪声方向发展，制造业对齿轮的设计和强度提出了更高的要求。 - Optimization design for low noise gear transmission system
低噪声齿轮变速传动系统优化设计 - The tests indicate that the system can shift automatically from low gear to high or from high gear to low according to the optimal dynamic and economic shift pattern.
实验表明，该系统可以按最佳动力性换档规律和最佳经济性换档规律自动从低档升入高档或从高档降到低档。 - On the purpose of improving efficiency of continuously variable transmission with reflux power, efficiency of previous system under low gear and reverse gear have been analyzed to optimize its structure based on analysis of speed modulation characteristic and transmission efficiency of transmission system.
在回流式无级自动变速传动系统调速特性和传动效率分析的基础上，以提高效率为出发点，通过对原有系统低速档、倒档工况下的效率分析，并对原有结构进行了优化。 - These depend on various factors related to the overall set up of the car, the fuel load variation, low gear revs and high gears revs.
取决于许多车辆的整体状况，诸如载油量的差异、高档位和低档位的转速。 - She selected a low gear and started down the track carefully.
她选了低速挡小心翼翼地沿小径下行。 - During the mass production of automobile gears and motorcycle gears, hobbing-shaving-honing process or hobbing-grinding process is generally used. Due to the high efficiency and the low cost of gear shaving, hobbing-shaving-honing process is more widely used in gear production.
在汽摩齿轮大批量生产中，一般采用滚剃珩工艺或滚磨工艺制造，由于剃齿加工效率高，成本低，滚剃珩工艺在生产中应用较为广泛。 - Study on low Viscosity EP Gear Oil
低粘度极压齿轮润滑油研究 - Particular design of spring leaf weighing mechanism and low electromagnetism gear speed detector, the weighing signals and the tachometer signals are accurate and stable;
独特的簧片称量机构，以及独特的弱磁式齿轮侧速装置的设计，称重和测速信号准确稳定； - Automotive spiral bevel gears and manufacturing characteristics, analyzes the reasons for the low spiral bevel gear meshing, and proposed measures for improvement, small batch and production testing proved correct and effective improvements.
同时，针对汽车螺旋锥齿轮结构与制造特点，分析了螺旋锥齿轮啮合率低的原因，并提出了改进措施，通过小批量与生产试验证明了其改进措施正确与有效。